![]() All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. Windows 2008 R2 Server with Active Directory services and NPS role installed.The information in this document is based on these software and hardware versions: There are no specific requirements for this document. ASA sends RADIUS authentication requests on behalf of VPN users and NPS authenticates them against Active Directory. Basically, the ASA is a RADIUS client to an NPS RADIUS server. Similarly, in Windows 2008 Server, NPS is the implementation of a RADIUS server. It is equivalent to Windows 2003 Server, IAS (Internet Authentication Service), which is the implementation of a RADIUS server to provide remote dial-in user authentication. NPS is one of the server roles offered by Windows 2008 Server. Other features offered by HyperTerminal are cut/copy/paste of configurations and logging of sessions.This document explains how to configure an Adaptive Security Appliance (ASA) to communicate with a Microsoft Windows 2008 Network Policy Server (NPS) with the RADIUS protocol so that the legacy Cisco VPN Client/An圜onnect/Clientless WebVPN users are authenticated against Active Directory.HyperTerminal can be used to telnet to devices, over the network, once they are configured.To talk to a Cisco device, HyperTerminal must be configured on the right COM port and at 9600 baud.That HyperTerminal is a serial and network terminal emulation program included with Windows.HyperTerminal can also log anything that scrolls by on the window to a log file, for record keeping or analysis. For example, you can do a show running-config, copy the output to the Windows clipboard, paste it into notepad, edit parts of it, and paste it back into your router’s configuration. HyperTerminal can be used to paste Cisco commands into your device so that you can more quickly configure devices. Thus, you don’t have to stop using HyperTerminal once you have configured your device. HyperTerminal can also be used to telnet to your Cisco network devices once they are configured with an IP address and are on the network. I suggest saving it with the name you gave it, cisco, so that you don’t have to configure it again next time. When you are done and try to close out HyperTerminal, you will be asked if you want to save this connection. You have successfully configured HyperTerminal and connected to your Cisco device. In the HyperTerminal window, you should see the boot up process for your device, like this: On the next window, change the Baud rate to 9600 and click OK. On the next window that appears, make sure that the “Connect Using” field says COM1 and click OK. Type in the word cisco for the connection name and click OK.Ĭonnect your Cisco device to your PC’s COM1 port but don’t turn it on yet. Note that this is not required but let’s go ahead and do it. HyperTerminal prompts you to create a new connection. Run HyperTerminal in Windows by going to Start > Programs > Accessories > Communications > HyperTerminal.Īfter clicking on the HyperTerminal icon, you will see this window: Connecting to your Cisco device with HyperTerminal In the case of the network, HyperTerminal is simply using the telnet protocol. HyperTerminal can either use the local serial interface for communications or the network. That device could be either a serial device, like a Cisco router, connected directly to your PC’s serial port OR a network device. ![]() What this means is that it offers you a text-based command prompt on a remote device. HyperTerminal is a terminal emulator program that runs in Windows. This article will show you how to configure HyperTerminal to talk to a new Cisco device. While there are a variety of serial terminal emulation programs available, most people use HyperTerminal to do this because it is included free with Windows. You must configure them from the command line using the serial-based console port on the switch or router. Most Cisco devices do not have a graphical Web-based interface by default.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |